Engineering, 30.03.2020 20:28 juju1085

A roller conveyor moves tote pans at 200 ft/min between a load station and an unload station, a distance of 250 ft. The time to load parts into a tote pan at the load station is 0.05 min/part. Each tote pan holds 12 parts. In addition, it takes 0.15 min to load a tote pan onto the conveyor. One worker is assigned to loading the parts and then loading the tote pan onto the conveyor. Determine (a) the spacing between tote pan centers flowing in the conveyor system, and (b) the flow rate of parts on the conveyor system. (c) Consider the effect of the unit load principle. Suppose the tote pans were smaller and could hold only one part rather than 12. Determine the flow rate in this case if it takes 0.10 min to load a tote pan onto the conveyor (instead of 0.15 min for

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

You know the right answer?

A roller conveyor moves tote pans at 200 ft/min between a load station and an unload station, a dist...

Questions