Engineering, 28.03.2020 04:02 22chandlerlashley
A simple medium access control protocol would be to use a fixed assignment time division multiplexing (TDM) scheme. Each station is assigned one time slot per cycle for transmission. For the bus, the length of each slot is the time to transmit 100 bits plus the ene-to-end propagation delay. For the ring, assume a delay of 1 bit time per station, and assume that a round-robin assignment is used. Stations monitor all time slots for reception.
Assume a propagation time of 2×108 m/s. For N stations, what is the throughput per station for :
a. A 1-Km, 10 Mbps baseband bus
b. A 10-Mbps ring with a total length of 1Km
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
You know the right answer?
A simple medium access control protocol would be to use a fixed assignment time division multiplexin...
Questions
Social Studies, 22.06.2019 03:30
Mathematics, 22.06.2019 03:30
Mathematics, 22.06.2019 03:30
History, 22.06.2019 03:30
History, 22.06.2019 03:30
