Engineering, 27.03.2020 04:29 devinmoore8686
Design a circuit with the following criteria. Assume availability of +5V and +9V power sources. i. Input signal that operates between Vin = 0V to +5V, and capable of delivering 0.9mA. ii. Output to control an external 4 ohm grounded load powered by 9V. a) Determine the current applied on the external output load? What type of circuit system do you think you need? b) Draw your designed circuit. Make sure to size passive elements, label actual P/N components, use datasheet values, etc as part of your design process. Must show your work to justify your design.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500Ā°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
Design a circuit with the following criteria. Assume availability of +5V and +9V power sources. i. I...
Questions
Mathematics, 10.12.2020 19:50
Arts, 10.12.2020 19:50
Mathematics, 10.12.2020 19:50
Health, 10.12.2020 19:50
Mathematics, 10.12.2020 19:50
Health, 10.12.2020 19:50
Mathematics, 10.12.2020 19:50
Mathematics, 10.12.2020 19:50
Mathematics, 10.12.2020 19:50
Chemistry, 10.12.2020 19:50
