Engineering, 26.03.2020 16:52 destinywashere101

Measurements of drag force are made on a model automobile in a towing tank filled with fresh water. The model length scale is 1/8 that of the prototype. Let FD = f(rho, V, L, μ).
a. State the conditions required to ensure a dynamic similarity between the model and prototype.
b. Determine the fraction of the prototype speed in the air at which the model test should be made in water to ensure dynamically similar conditions.
c. Measurements made at various speeds show that the dimensionless force ratio becomes constant at model test speeds above Vm = 6 m/s. The drag force measured during a test at this speed is FDm = 193 N. Calculate the drag force expected on the prototype vehicle operating at 97 km/hr in the air.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

You know the right answer?

Measurements of drag force are made on a model automobile in a towing tank filled with fresh water....

Questions