Engineering, 24.03.2020 23:31 mtropical6753

A 21-tooth pinion rotating at 1800 rpm meshes with a 33-tooth gear in a simple spur gear set. Both pinion and gear are manufactured to a quality level of 9. A reliability of 0.9 has been specified, and the transmitted tangential load is 2800 lb. Conditions are such that Km = 1.7. It is proposed that standard 25-degree, full-depth teeth be used, with both pinion and gear hobbed from an AISI 4140 nitride steel. The diametral pitch is 6, and the face width 2.000 in.
(a) Determine the bending stress using the AGMA equations (for the gear most likely to fail).
(b) In the gearset, which do you expect to fail first - the pinion or the gear?
(c) Determine the pitch diameter of the pinion and pitch-line velocity of the gearset.
(d) Determine the dynamic factor K_v.
(e) Determine the bending geometry factor (J) and application factor.
(f) Determine the size factor (K_s), rim thickness factor (K_B), and idler factor (K_1).
(g) Determine the pinion-tooth bending stress How would you determine the factor of safety? Describe qualitatively.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

You know the right answer?

A 21-tooth pinion rotating at 1800 rpm meshes with a 33-tooth gear in a simple spur gear set. Both p...

Questions