Engineering, 21.03.2020 10:01 Udfhut7500

Problem: design the following rectangular floor beam for a building.
Some design information are given parametrically:
A = first two digits of your student ID.
B = last three digits of your student ID.
The beam has a simple span of A ft. The uniform service load is B lbs/ft live load. Consider the self-weight of the beam as dead load.
Assume f’c = 4,000 psi, fy = 60,000 psi, and #3 stirrups.
Required:
a) Conduct a free-beam design for the above conditions.
b) Sketch the final design showing a cross-section (ACAD or clean hand-sketch).

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

You know the right answer?

Problem: design the following rectangular floor beam for a building.
Some design information...

Questions