Engineering, 17.03.2020 20:36 moonk7733

Cuts-R-Us provides low cost haircuts at a shopping center in Boise, Idaho. During the day, customers arrive at an average rate of nine per hour following a Poisson distribution. After a customer is in a cosmetician s chair, it takes an average of 18 minutes for the haircut to be completed, with the actual service time following a Poisson distribution. a. If there are three cosmeticians on duty, how long will customers have to wait on average before receiving service, and how many customers are typically waiting for service? b. If there are four cosmeticians on duty, how long will customers have to wait on average before receiving service, and how many customers are typically waiting for service? c. If there are five cosmeticians on duty, how long will customers have to wait on average before receiving service, and how many customers are typically waiting for service? d. If you managed this store, how many cosmeticians would you employ and why?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Cuts-R-Us provides low cost haircuts at a shopping center in Boise, Idaho. During the day, customers...

Questions