Engineering, 16.03.2020 18:44 nessuhbae6722

A convergent–divergent nozzle is designed to expand air from a chamber in which the pressure is 800 kPa and the temperature is 40°C to give Mach 2.5. The throat area of the nozzle is 0.0025 m2. Find a. The flow rate through the nozzle under design conditions b. The exit area of the nozzle c. The design back-pressure and the temperature of the air leaving the nozzle with this back-pressure d. The lowest back-pressure for which there is only subsonic flow in the nozzle e. The back-pressure at which there is a normal shock wave on the exit plane of the nozzle f. The back-pressure below which there are no shock waves in the nozzle g. The range of back-pressures over which there are oblique shock waves in the exhaust from the nozzle h. The range of back-pressures over which there are expansion waves in the exhaust from the nozzle i. The back-pressure at which a normal shock wave occurs in the divergent section of the nozzle at a point where the nozzle area is half way between the throat and the exit plane areas

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

You know the right answer?

A convergent–divergent nozzle is designed to expand air from a chamber in which the pressure is 800...

Questions