Engineering, 16.03.2020 16:58 suselygonza

When removing the pistons and rods assemblies from a cylinder block technician a positions the throw of the crankshaft at the top of its stroke and removes the connecting rod nuts and cap, tech b covers the rod bolts with protectors and pushes the piston and rods assembly out with the wooden hammer handle or wooden drift and supports the piston as it comes out of the cylinder, who is correct?1 tech a2 tech b3 both a & b4 neither a&b

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

Answer

You know the right answer?

When removing the pistons and rods assemblies from a cylinder block technician a positions the throw...

Questions