Engineering, 13.03.2020 04:32 yanelyportillo7

A piston-cylinder assembly contains 2 lbm of water, initially at 100 lbf/in.2 and 400o
F. The water undergoes two processes in series: a constant pressure process followed by a constant volume
process. At the end of the constant volume process, the temperature is 300o
F and the water is a two-phase liquid-vapor mixture with a quality of 60%. Neglect kinetic and potential energy
effects.

(a) Sketch T-v and p-v diagrams showing the key states and the processes.
(b) Determine the work and heat transfer for each process, all in Btu.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 19:20

List 3 options on how to reduce knocking problens during engine process,

Answers: 2

Answer

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

You know the right answer?

A piston-cylinder assembly contains 2 lbm of water, initially at 100 lbf/in.2 and 400o
F. The...

Questions