Engineering, 12.03.2020 05:36 sharkboy3780

6.15. In an attempt to conserve water and to be awarded LEED (Leadership in Energy and Environmental Design) certification, a 20,000-liter cistern has been installed during construction of a new building. The cistern collects water from an HVAC (heating, ventilation, and air-conditioning) system designed to provide 2830 cubic meters of air per minute at 22°C and 50% relative humidity after converting it from ambient conditions (31°C, 70% relative humidity). The collected condensate serves as the source of water for lawn maintenance. Estimate (a) the rate of intake of air at ambient conditions in cubic feet per minute and (b) the hours of operation required to fill the cistern

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What are the major differences between injection molding and extrusion?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

You know the right answer?

6.15. In an attempt to conserve water and to be awarded LEED (Leadership in Energy and Environmental...

Questions