Engineering, 10.03.2020 01:58 youngcie04
A milling operation was used to remove a portion of a solid bar of square cross section. Forces of magnitude P = 18 kN are applied at the centers of the ends of the bar. Knowing that a = 30 mm and σall = 135 MPa, determine the smallest allowable depth d of the milled portion of the bar.
Answers: 1
for the milled portion of bar.
Another question on Engineering
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
You know the right answer?
A milling operation was used to remove a portion of a solid bar of square cross section. Forces of m...
Questions
English, 20.10.2019 18:30
Mathematics, 20.10.2019 18:30
History, 20.10.2019 18:30
Biology, 20.10.2019 18:30
Mathematics, 20.10.2019 18:30
Mathematics, 20.10.2019 18:30
Biology, 20.10.2019 18:30
