subject
Engineering, 09.03.2020 03:29 FireFlight

Problem 22 in Gilat. (2 points)
22. The voltage V c t seconds after closing the switch
in the circuit shown is given by:
Ve=V (1-e4/RC)
Plot V c as a function of t for 0 axes. V. = 36 V, R = 2, 500 12, and C = 1, 200 uF.
CLV
Tips: 1. Use t = [0:0.01:15]
2. 1 uF = 1.0e-6 F
Matlab

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
question
Engineering, 04.07.2019 18:20
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
question
Engineering, 06.07.2019 04:10
Aheat pump with refrigerant-134a as the working fluid is used to keep a space at 25°c by absorbing heat from geothermal water that enters the evaporator at 500c at a rate of 0.065 kg/s and leaves at 40°c. the refrigerant enters the evaporator at 20°c with a quality of 23 percent and leaves at the inlet pressure as saturated vapor. the refrigerant loses 300 w of heat to the surroundings as it flows through the compressor and the refrigerant leaves the compressor at 1.4 mpa at the same entropy as the inlet. determine: (a) the degrees of subcooling of the refrigerant in the condenser, b)-the mass flow rate of the refrigerant . (c) the heating load and the cop of the pump, and d)-the theoretical minimum power input to the compressor for the same heating load.
Answers: 3
You know the right answer?
Problem 22 in Gilat. (2 points)
22. The voltage V c t seconds after closing the switch
i...
Questions
question
Mathematics, 06.11.2020 23:40
question
Computers and Technology, 06.11.2020 23:40
question
Mathematics, 06.11.2020 23:40
question
Mathematics, 06.11.2020 23:40
question
Chemistry, 06.11.2020 23:40
question
Mathematics, 06.11.2020 23:40
question
Mathematics, 06.11.2020 23:40
Questions on the website: 13722360