Engineering, 07.03.2020 02:59 pilararcos

Problem 4 You are designing a circuit to drive LED1, using the following circuit. The datasheet for the LED specifies that VF = 2 V. Treat LEDs as diodes with the constant voltage model. (a) Find the expected current through the LED I(LED) when VF = 2 V (b) After testing, it is determined that some LEDs within a batch do not light up correctly in the circuit for part a. It is suspected that this is because there is some variation in among the LEDs in the batch. Find the maximum value of VF such that the circuit above stops working I(LED) drops to zero so you can characterize this problem and report it to the manufacturer.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

You know the right answer?

Problem 4 You are designing a circuit to drive LED1, using the following circuit. The datasheet for...

Questions