Engineering, 07.03.2020 00:31 kkpowell

Two plates are held together by square stainless steel bars with thickness of 12 mm. each bar has a thermal conductivity of 12 w/mk, a specific heat of 500 J/kgK, and a density of 7.9 g/cm^3. The bars are situated in between the two plates, and they are occasionally submerged in hot liquid at 300°C with a convec- tion heat transfer coefficient of 96 W/m2.K. The length of each bar that is exposed to the hot liquid is 25 mm with an initial temperature of 20°C. The maximum use temperature allowed for ASTM A479 904L bars is 260°C . If the bars are sub- merged in the hot liquid for 5 min, will they be in compliance with the ASME code? How long will it take for the bars to reach the maximum use temperature?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

Answer

Engineering, 06.07.2019 02:30

In a unit cell of fcc structure, indicate the position of one of the tetrahedral interstitial sites by plotting the corresponding tetrahedron. do the same for one of the octahedral interstitial sites (in a separate fcc unit cell). mark the positions of all the tetrahedral and octahedral interstitial sites in the unit cells. how many equivalent tetrahedral sites and how many equivalent octahedral sites are contained in a fcc unit cell, respectively. what is the coordination number for a tetrahedral site and what is the coordination number for an octahedral site?

Answers: 2

Answer

You know the right answer?

Two plates are held together by square stainless steel bars with thickness of 12 mm. each bar has a...

Questions