Engineering, 06.03.2020 09:58 kat2177

Find the value of R2 required if vs = 18 V , R1 = 50 kΩ , and the desired no-load output voltage is vo = 6 VPart b)Several different loads are going to be used with the voltage divider from Part A. If the load resistances are 300 kΩ , 200 kΩ , and 100 kΩ , what is the output voltage that is the most different from the design output voltage vo = 6 V ?part c)The circuit designer wants to change the values of R1 and R2 so that the design output voltage vo = 6 V is achieved when the load resistance is RL = 200 kΩ rather than at no-load. The actual output voltage must not drop below 5.4 V when RL = 100 kΩ . What is the smallest resistor value that can be used forR1?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

You know the right answer?

Find the value of R2 required if vs = 18 V , R1 = 50 kΩ , and the desired no-load output voltage is...

Questions