Engineering, 06.03.2020 09:15 gg68814
A solid titanium alloy [G=114 GPa] shaft that is 730 mm long will be subjected to a pure torque of T=150 N⋅m. Determine the minimum diameter required if the shear stress must not exceed 135 MPa and the angle of twist must not exceed 3°. Report both the maximum shear stress τ and the angle of twist φ at this minimum diameter.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg
Answers: 2
Engineering, 04.07.2019 19:20
The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal
Answers: 3
Engineering, 04.07.2019 19:20
Ashielded metal arc-welding operation is accomplished in a work cell by a fitter and a welder. the fitter takes 5.5 min to load components into the welding fixture at the beginning of the work cycle, and 1.5 min to unload the completed weldment at the end of the cycle. the total ength of the weld seams 1200 mm, and the travel speed used by the welder averages 300 mm/min. every 600 mm of seam length, the welding stick must be changed, which takes 0.8 min. while the fitter is working, the welder is idle (resting): and while the welder is working the fitter is idle. (a) determine the average arc-on time as a fraction of the work cycle time. (b) how much improvement in arc-on time would result if the welder used flux-cored arc welding (manually operated), given that the spool of weld wire must be changed every 10 weldments, and it takes the welder 5.0 min to accomplish the change? (c) what are the production rates for these two cases (weldments completed per hour)? attach your work and solutions.
Answers: 1
A solid titanium alloy [G=114 GPa] shaft that is 730 mm long will be subjected to a pure torque of...
History, 19.11.2020 17:30
Mathematics, 19.11.2020 17:30
Mathematics, 19.11.2020 17:30
Computers and Technology, 19.11.2020 17:30
Mathematics, 19.11.2020 17:30
Mathematics, 19.11.2020 17:30
Mathematics, 19.11.2020 17:30
Mathematics, 19.11.2020 17:30
Physics, 19.11.2020 17:30