Engineering, 05.03.2020 23:01 addisonwiles
A force transducer system is needed to measure a sinusoidal signal. Derived from the logarithmic amplitude decay test, the system has a damping ratio of 0.6 and natural frequency of 1500 Hz. Estimate the frequency bandwidth of this system and plot M(f) as a function of f/fn.
What is the upper cut-off frequency?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
A force transducer system is needed to measure a sinusoidal signal. Derived from the logarithmic amp...
Questions
Mathematics, 27.03.2020 01:29
History, 27.03.2020 01:29
History, 27.03.2020 01:29
History, 27.03.2020 01:29
Geography, 27.03.2020 01:29
Social Studies, 27.03.2020 01:29
Mathematics, 27.03.2020 01:29
