Engineering, 05.03.2020 07:45 kaniyawilhite
The tooling is called a die in all of the following bulk deformation processes except which one: (a) drawing, (b) extrusion, (c) forging, or (d) rolling?
Answers: 3
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
The tooling is called a die in all of the following bulk deformation processes except which one: (a)...
English, 12.01.2020 06:31
Mathematics, 12.01.2020 06:31
History, 12.01.2020 06:31
Geography, 12.01.2020 06:31
English, 12.01.2020 06:31
Mathematics, 12.01.2020 06:31
Mathematics, 12.01.2020 06:31
Health, 12.01.2020 06:31
Mathematics, 12.01.2020 06:31
English, 12.01.2020 06:31
History, 12.01.2020 06:31
Mathematics, 12.01.2020 06:31
Mathematics, 12.01.2020 06:31
Chemistry, 12.01.2020 06:31