subject
Engineering, 03.03.2020 00:44 hardwick744

The cutaway of the gun barrel shows a projectile moving through the barrel. The projectile’s exit speed is vs = 1650 m/s (relative to the barrel), the projectile’s mass is 18.5 kg, the length of the barrel is L = 4.4 m, the acceleration of the projectile down the gun barrel is constant, and θ is increasing at a constant rate of 0.18 rad/s.
Determine the following:
(a) The acceleration of the projectile.
(b) The pressure force acting on the back of the projectile.
(c) The normal force on the gun barrel due to the projectile.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
You know the right answer?
The cutaway of the gun barrel shows a projectile moving through the barrel. The projectile’s exit sp...
Questions
Questions on the website: 13722363