Engineering, 02.03.2020 21:40 hannahmckain
Bar (1) has a length of L1 = 2.50 m, and bar (2) has a length of L2 = 0.65 m. Initially, there is a gap of Δ = 3.5 mm between the rigid plate at B and bar (2). After application of the loads P to the rigid plate at B, the rigid plate moved to the right, stretching bar (1) and compressing bar (2). The normal strain in bar (1) was measured as 2,740 μm/m after the loads P were applied. Determine the normal strain produced in bar (2).
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
You know the right answer?
Bar (1) has a length of L1 = 2.50 m, and bar (2) has a length of L2 = 0.65 m. Initially, there is a...
Questions
Mathematics, 07.03.2020 05:10
