Engineering, 02.03.2020 19:46 MJKjmkp1
We would like to measure the density of an ideal gas. We know the ideal gas law provides rho = P/RT, where P represents pressure, R is a constant equal to 287.058 J/kg-K and T represents temperature. We use a pressure transducer to take 15 measurements, all under the same conditions. The sample mean and standard deviation obtained from these 15 pressure measurements are 120,300 Pa and 6,600 Pa respectively. The pressure transducer specifications sheet reports an accuracy of 0.6% of the full-scale output (FSO) and a sensitivity error of 0.3% of the FSO. The FSO for this instrument is 180,000 Pa.
In addition, we use a thermocouple to measure the gas temperature. We take 20 temperature measurements and obtain a sample mean and standard deviation of 340 K and 8 K, respectively. The accuracy of the thermocouple is 0.25% of the reading and its calibration error is +_ 2 K.
1. Calculate the density of the ideal gas and its total uncertainty for a 95% probability.
Answers: 1
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
We would like to measure the density of an ideal gas. We know the ideal gas law provides rho = P/RT,...
Mathematics, 25.06.2019 11:00
Arts, 25.06.2019 11:00
English, 25.06.2019 11:00
Mathematics, 25.06.2019 11:00
Mathematics, 25.06.2019 11:00
Social Studies, 25.06.2019 11:00
History, 25.06.2019 11:00
History, 25.06.2019 11:00
English, 25.06.2019 11:00