Engineering, 27.02.2020 19:26 zahrast14

A rigid bar pendulum is attached to a cart, which moves along the horizontal plane. The rigid bar has a center of mass at L/2. The pendulum is pinned to the cart, and a torsional spring is located between the cart and the pendulum. Assume the torsional spring does not cause a dynamic effect on the cart (but does affect the rigid bar). Recall for a pinned attachment we can assume reaction forces in the horizontal and vertical directions. There is a horizontal force F(t) that acts on the cart, which is also attached to a wall on the opposite side through a linear spring. Ignore friction.

a. Identify the number of degrees of freedom, and define a choice of generalized coordinates.
b. Find the equations of motion using Newton's second law.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

You know the right answer?

A rigid bar pendulum is attached to a cart, which moves along the horizontal plane. The rigid bar ha...

Questions