Engineering, 27.02.2020 05:28 libertycooper

A. Energy transfer for which the sole effect on everything external to the system could have been the raising of a weight 2. Change in total energy B. A sequence of processes that begins and ends at the same state 3. Adiabatic C. Energy transfer induced only as a result of a temperature difference between a system and its surroundings 4. Sign convention for work D. A cycle where energy is transferred by heat into the system undergoing the cycle from the cold body and energy is transferred by heat from the system to the hot body 5. Change in specific kinetic energy E. Energy transfer out of the system is considered positive 6. Energy balance F. A process involving no energy transfer by heat 7. Thermodynamic cycle G. mg(z2 2 z1) 8. Energy transfer by heat H. 1/2 (V2 2 2 V2 1) 9. Change in potential energy I. DE

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

Engineering, 05.07.2019 23:20

Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket

Answers: 3

Answer

You know the right answer?

A. Energy transfer for which the sole effect on everything external to the system could have been th...

Questions