subject
Engineering, 26.02.2020 05:19 shanua

(d) Arches NP is known for its spectacular arches that develop in the jointed areas of the park. Placemark Problem 2d flies you to Landscape Arch, the arch with the largest span in Arches NP. If the stresses that stretched the rock to form the joints were oriented perpendicular to the joint surfaces and the rock fins that contain the arches, what was the direction that the rocks were stretched?
☐ N-S
☐ E-W
☐ NW-SE
☐ NE-SW

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
You know the right answer?
(d) Arches NP is known for its spectacular arches that develop in the jointed areas of the park. Pla...
Questions
question
Mathematics, 09.04.2020 19:26
question
Mathematics, 09.04.2020 19:26
question
Mathematics, 09.04.2020 19:27
question
History, 09.04.2020 19:27
Questions on the website: 13722363