Engineering, 25.02.2020 23:18 mvasquez3122p4vahv

A Dual cycle engine is analyzed using the cold air standard method. Given the conditions at state 1, compression ratio (r), and cutoff ratio (rc) determine the efficiency and other values listed below.
Note: The specific heat ratio and gas constant for air are given as k=1.4 and R=0.287 kJ/kg-K respectively.

--Given Values--
T1 (K) = 328
P1 (kPa) = 190
r = 14
rp = 1.3
rc = 1.3

a) Determine the specific internal energy (kJ/kg) at state 1.
b) Determine the temperature (K) at state 2.
c) Determine the pressure (kPa) at state 2.
d) Determine the specific internal energy (kJ/kg) at state 2.
e) Determine the temperature (K) at state 3.
f) Determine the pressure (kPa) at state 3.
g) Determine the specific internal energy (kJ/kg) at state 3.
h) Determine the specific enthalpy (kJ/kg) at state 3.
i) Determine the temperature (K) at state 4.
j) Determine the pressure (kPa) at state 4.
k) Determine the specific enthalpy (kJ/kg) at state 4.

l) Determine the temperature (K) at state 5.

m) Determine the pressure (kPa) at state 5.

n) Determine the specific internal energy (kJ/kg) at state 5.

o) Determine the net work per cycle (kJ/kg) of the engine.

p) Determine the heat addition per cycle (kJ/kg) of the engine.

q) Determine the efficiency (%) of the engine.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b.s. and b.s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

Answer

You know the right answer?

A Dual cycle engine is analyzed using the cold air standard method. Given the conditions at state 1,...

Questions