Engineering, 25.02.2020 22:30 khaz1430

A column in a building is subjected to the following load effects:

9 kips compression from dead load.
5 kips compression from roof live load.
6 kips compression from snow.
7 kips compression from.
3 inches of rain accumulated on the roof.
8 kips compression from wind

a. If load and resistance factor design is used, determine the factored load (required strength) to be used in the design of the column. Which AISC load combination controls?
b. What is the required design strength of the column?
c. What is the required nominal strength of the column for a resistance factor phi of 0.90?
d. If allowable strength design is used, determine the required load capacity (required strength) to be used in the design of the column. Which AISC load combination controls?
e. What is the required nominal strength of the column for a safety factor Ohm of 1.67?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the main objective of using reheat rankine cycle?

Answers: 3

Answer

You know the right answer?

A column in a building is subjected to the following load effects:

9 kips compression f...

Questions