subject
Engineering, 22.02.2020 02:28 hannahmjohnson0443

A large lake with a volume of 2.0 x 109 ft3 is filled by an inflow stream with a flow rate of 20 ft/s and a non-conservative pollutant concentration of 5 ppm. A sewage outfall also discharges into the large lake with a flow rate of 3.5 ft3/s and a non-conservative pollutant concentration of 30 ppm. A outflow stream leaves the lake with the same flow rate of the inflow stream plus the outfall. The non- conservative pollutant has a decay rate coefficient of 0.20/day. Assume the pollutant is completely mixed in the lake and there is no evaporation or other gains or losses. What would be the steady state concentration in the outflow stream leaving the large lake? 1.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
You know the right answer?
A large lake with a volume of 2.0 x 109 ft3 is filled by an inflow stream with a flow rate of 20 ft/...
Questions
question
Mathematics, 24.09.2020 15:01
question
History, 24.09.2020 15:01
Questions on the website: 13722361