Engineering, 22.02.2020 02:05 lillysiege

Some chemical reaction is being run inside a sealed gas cylinder. During the reaction, a gaseous product is formed. The pressure P exerted by the gas has been measured five times. A gauge calibrated in units of psig was used Data from the measurements are provided below Table 1. Pressure measurements of the oxygen generated by chemical reaction inside a gas cylinder Run d P (psig) 21.0 20.2 20.7 21.3 20.5 8. Estimate the Type A uncertainty in these measurements. Be sure to include the units. Estimate the Type B uncertainty associated with these measurements, Be sure to include units. Determine the uncertainty in the measurement of pressure in the cylinder. Be sure to include units. State your a. answer as average +/-uncertainty.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

You know the right answer?

Some chemical reaction is being run inside a sealed gas cylinder. During the reaction, a gaseous pro...

Questions