subject
Engineering, 22.02.2020 00:25 fredericksppeedddf

FindFile Class Interface FindFile(int maxFiles): This constructor accepts the maximum number of files to find. void directorySearch(String target, String dirName): The parameters are the target file name to look for and the directory to start in. This will save the file locations (i. e., file path, starting from dirName) in some private class data structure. int getCount(): This accessor returns the number of matching files found String[] getFiles(): This getter returns the array of file locations, up to maxFiles in size.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
You know the right answer?
FindFile Class Interface FindFile(int maxFiles): This constructor accepts the maximum number of file...
Questions
question
Mathematics, 22.01.2021 14:00
question
Mathematics, 22.01.2021 14:00
question
Mathematics, 22.01.2021 14:00
question
Mathematics, 22.01.2021 14:00
question
Mathematics, 22.01.2021 14:00
question
Biology, 22.01.2021 14:00
Questions on the website: 13722362