Engineering, 21.02.2020 19:57 odalysgise

An Otto cycle engine is analyzed using the cold air standard method. Given the conditions at state 1, compression ratio (r), and pressure ratio (rp). The specific heats for air are Cp = 1.0045 kJ/kg-K and Cv = 0.7175 kJ/kg-K.

T1 = 300K

P1 = 100 kPa

r = 10

rp = 1.65

a) Determine the temperature (K) at state 2.

b) Determine the pressure (kPa) at state 2.

c) Determine the pressure (kPa) at state 3.

d) Determine the temperature (K) at state 3.

e) Determine the temperature (K) at state 4.

f) Determine the pressure (kPa) at state 4.

g) Determine the net work output (kJ/kg/cycle) for the engine.

h) Determine the heat addition (kJ/kg/cycle) for the engine.

i) Determine the efficiency (%) of the engine.

Points will be given to answer showing all the work done to get right answer.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Wiy doeres rere okhn a pump whon working betwon the same pressure range?

Answers: 2

Answer

You know the right answer?

An Otto cycle engine is analyzed using the cold air standard method. Given the conditions at state 1...

Questions