subject
Engineering, 21.02.2020 17:59 fernandaretanaoxwln0

Sections of this interstate have speed limits of 65mph. A construction site is located on this interstate near Boise, ID. In the construction site, the speed limit is reduced to 20 mph. A warning sign reading "WORK ZONE: 20 MPH SPEED ZONE" is required to be put before the start of the construction site so as to allow drivers to decelerate before entering the work zone. The sign is located 20 ft. to the side of the road, the deceleration rate of the vehicle is 11 ft./sec2 (recommended maximum deceleration rate by AASHTO) and the driver is assumed to have 20/40 vision. You may assume a perception time of 1 sec, an interpretation rate of 3 words/sec, and a decision time of 0.5 sec. Assuming the road is level answer the following questions.

a. What should be the minimum distance away from the warning sign from where the driver is able to read the warning? (Assuming 10 degree cone of vision and the vehicle is moving on the side of the road i. e. lateral distance between car and warning sign is 20 ft.)

b. Determine the total time taken by driver before he applies brakes. Also, determine the distance travelled during perception, interpretation, and reaction.

c. Assuming that the driver reacts only once he is out of 10 degree cone of vision, calculate the minimum distance away from the start of the construction site where a warning sign must be located to allow drivers to decelerate before entering the work zone.

d. Determine the minimum size of the text on the sign.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
question
Engineering, 04.07.2019 19:20
Aseries piping system conveys methyl alcohol. the system consists of 70 m of 1- nominal pipe follow by 50 m of 2-nominal pipe, both schedule 40 commercial steel. the 1-nominal pipe contains 3 90° elbows (regular) anda fully open gate valve, all threaded. the pressure drop through the system is 150 kpa. determine the volume flow rate through the system that is horizontally laid.
Answers: 1
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
You know the right answer?
Sections of this interstate have speed limits of 65mph. A construction site is located on this inter...
Questions
question
Mathematics, 13.11.2020 19:10
question
Mathematics, 13.11.2020 19:10
question
Mathematics, 13.11.2020 19:10
Questions on the website: 13722367