Engineering, 21.02.2020 03:31 SchoolFirst9811

If the small strain tensor at a point in a body made of a moldable plastic could be determined experimentally by measuring the unit extensions in six directions at the point (the coordinate directions and the three directions bisecting the angles between the axes: em for the direction between X1 and X2, en between X2 and X3, et between X3 and X1), determine the shear strain components E12, E23, and E31 in terms of the six measured unit extensions.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

Engineering, 05.07.2019 04:30

Technician a says that in a worm gear steering system, most excessive steering free play is usually found in the gearbox. technician b says that in a rack-and-pinion steering system, excessive free play can be found in the bushings. who is correct?

Answers: 2

Answer

You know the right answer?

If the small strain tensor at a point in a body made of a moldable plastic could be determined exper...

Questions