Engineering, 20.02.2020 22:30 samueltaye
Nitrogen can be liquefied using a Joule-Thomson expansioni process. This is done by rapidlyl and adiabatically expandign cold nitrogen gas from high pressure to a low pressure. If nitrogen at 135 K and 20 MPa undergoes a Joule-Thomson expansion to 0.4 MPa,
a. Estimate the fraction of vapor and liquid present after the expansion, and the emperature of this mixture using the pressure-enthalpy diagram for nitrogen.
b. Repeat the calculation assuming nitrogen to be an ideal gas with Cp* = 29.3 J/molK
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Nitrogen can be liquefied using a Joule-Thomson expansioni process. This is done by rapidlyl and adi...
Mathematics, 06.07.2019 11:00
Mathematics, 06.07.2019 11:00
Biology, 06.07.2019 11:00
Mathematics, 06.07.2019 11:00
Social Studies, 06.07.2019 11:00
Mathematics, 06.07.2019 11:00
English, 06.07.2019 11:00
Mathematics, 06.07.2019 11:00
Mathematics, 06.07.2019 11:00