subject
Engineering, 20.02.2020 00:20 mtammy884

Output each floating-point value with three digits after the decimal point, which can be achieved as follows: printf("%0.3lf", yourValue); Ex: If the input is 8 10 5 4, the output is: 1600 6 1600.000 6.750 Note that fractions aren't discarded, and that overflow does not occur for the test case with large values.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
You know the right answer?
Output each floating-point value with three digits after the decimal point, which can be achieved as...
Questions
question
Mathematics, 22.05.2020 02:08
question
History, 22.05.2020 02:08
question
English, 22.05.2020 02:08
question
Mathematics, 22.05.2020 02:08
Questions on the website: 13722361