Engineering, 17.02.2020 16:38 dylannsquats
Calculate the room-temperature forging force for a solid, cylindrical workpiece made of 5052- O aluminum that is 3.5 in. high and 5 in. in diameter and is to be reduced in height by 30%. Let the coefficient of friction be 0.15. Estimate the forging force for the workpiece, assuming that it is a complex forging and that the projected area of the ash is 30% greater than the projected area of the forged workpiece. To what thickness can a solid cylinder of
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
Calculate the room-temperature forging force for a solid, cylindrical workpiece made of 5052- O al...
Questions
Computers and Technology, 29.07.2019 01:30
English, 29.07.2019 01:30
Social Studies, 29.07.2019 01:30
Health, 29.07.2019 01:30
