We used the mesh-current method to identify the meshes and assign the mesh currents; identified the special case of a current source as a component in only one mesh, which fixed the mesh current for that mesh; wrote a KVL equation for each mesh where the current is unknown; wrote a dependent-source constraint equation for each dependent source; solved the KVL equations and constraint equation for the unknowns; and checked the solution by verifying that the power in the circuit balances. Now use the calculated mesh current values to find the voltage vo?

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan