subject
Engineering, 05.02.2020 21:50 ICAMARON5070

Awell-insulated rigid tank is divided into two regions by a movable partition through which heat can flow via conduction. in the left region air exists with the following properties (2 kg, 5 bar, 350 k). in the right region co exists with the following properties (4 kg, 2 bar, 450 k). a pin holds the partition in place. the pin is removed and the air and co achieve pressure and temperature equilibrium. use a control volume that includes the air, the co and the partition. neglect the mass of the partition. a. assume constant specific heat for both air and co. look up the necessary specific heat values at an estimated average temperature of 400 k. b. determine the final temperature. c. using a new, more accurate, average air temperature and a new, more accurate, average co temperature, estimate how far off, in percent, the original specific heat estimates at 400 k are.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
You know the right answer?
Awell-insulated rigid tank is divided into two regions by a movable partition through which heat can...
Questions
question
Mathematics, 10.02.2021 07:00
question
Mathematics, 10.02.2021 07:00
question
Mathematics, 10.02.2021 07:00
Questions on the website: 13722367