subject
Engineering, 23.01.2020 05:31 Theresab2021

Astudent team is to design a human-powered submarine for a design competition. the overall length of the prototype submarine is 4.85 m, and its student designers hope that it can travel fully submerged through water at 0.440 m/s. the water is freshwater (a lake) at t = 15 °c. the design team builds a one-fifth scale model to test in their university’s wind tunnel. a shield surrounds the drag balance strut so that the aerodynamic drag of the strut itself does not influence the measured drag. the air in the wind tunnel is at 25°c and at one standard atmosphere pressure. the students measure the aerodynamic drag on their model submarine in the wind tunnel. they are careful to run the wind tunnel at conditions that ensure similarity with the prototype submarine. their measured drag force is 5.75 n. "estimate the drag force" on the prototype submarine at the given conditions.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 18:20
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
You know the right answer?
Astudent team is to design a human-powered submarine for a design competition. the overall length of...
Questions
question
Advanced Placement (AP), 25.03.2021 01:00
question
Mathematics, 25.03.2021 01:00
question
English, 25.03.2021 01:00
question
English, 25.03.2021 01:00
question
Mathematics, 25.03.2021 01:00
Questions on the website: 13722363