Engineering, 22.01.2020 00:31 Martinez6354

Your goal is to navigate a robot out of a maze. the robot starts in the center of the maze facing north. you can turn the robot to face north, east, south, or west. you can direct the robot to move forward a certain distance, although it will stop before hitting a wall.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 06.07.2019 04:20

Consider a beam traveling through diamond and impinging upon the diamond-air interface. the critical angle of incidence for total internal reflection to occur is closest to the following value: select one: a)-22.50° b)-23.85 c)-24.30 d)-23.40° e)-none of the above

Answers: 3

Answer

Engineering, 06.07.2019 05:20

Acantilever of 3 m length with a t-shaped cross-section is loaded by three concentrated loads: w,-80 n at the free end, w 30 n, and w,-60 n at a distance of 1 m from the free end. all loads are applied at the outer edges of the flange as indicated in the sketch below. (a)-determine the maximum torsional shear stresses in the flange and in the web at distances 0.5 m and 2.5 m from the free end (sections i and ii marked in the sketch) b)- determine thefh end cross section assuming a shear modulus of 210 gpa.

Answers: 3

Answer

Engineering, 06.07.2019 05:30

Around steel bar, 20 mm in diameter and 400 mm long, is placed concentrically within a brass long. tube which has an outside diameter of 30 mm and thickness 4 mm. the tube is 400 mm the upper end of the vertically placed compound bar is rigidly fixed and a collar is fitted to the bottom end. the application of a load p results in the compound rod storing a total of 5 j of energy.calculate (a) the gradually applied load; (b) the suddenly applied load; (c) the impact load that falls 100 mm and induces 5 j of energy; (d) the instantaneous stresses in both materials; and (e) the instantaneous elongation of the compound rod (egt = 200 gpa and egr = 100 gpa).

Answers: 2

Answer

You know the right answer?

Your goal is to navigate a robot out of a maze. the robot starts in the center of the maze facing no...

Questions