subject
Engineering, 13.01.2020 21:31 royal6032

Suppose there are 3 routers in sequence between host a and host b, all of which use store-and-forward routing. what is the total end-to-end delay for a packet originating from host a with destination host b, under the following conditions. each of the link transmission rates are 2.1 mbps the total distance from host a to host b along its path of transmission is 130.4 km the speed of propagation through the transmission medium is is 2.5 x 108 m/s the packet size is 3 kib remember that you must also uplink from host a to the first router. give answer in milliseconds, rounded to 1 decimal place, without units (e. g. for 0.12345 seconds you would enter "123.5" without the quotes).

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:20
Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 Β°c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.
Answers: 3
question
Engineering, 06.07.2019 03:20
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
You know the right answer?
Suppose there are 3 routers in sequence between host a and host b, all of which use store-and-forwar...
Questions
question
English, 04.05.2021 14:00
question
Health, 04.05.2021 14:00
question
History, 04.05.2021 14:00
question
Spanish, 04.05.2021 14:00
question
Chemistry, 04.05.2021 14:00
question
English, 04.05.2021 14:00
question
English, 04.05.2021 14:00
Questions on the website: 13722359