subject
Engineering, 04.01.2020 06:31 peachijmin

Which one of the following activities is not exempt from licensure pursuant to chapter 471, f. s.? a person practicing engineering on property owned by him or her. a full time electrical engineer of progress energy corp. a civil engineer employed full time by the u. s. army corps of engineers. an independent consultant working on the design of an electrical distribution system project for progress energy corp. applicants for licensure with degrees from foreign institutions are required to document "substantial equivalency to abet criteria to the fbpe. they can do this by: providing a transcript from their institution to the board. providing a notarized certification that they have completed the requisite college credit hours set forth in rules 61615-20.007(2)(a) thru (2)(d), f. a.c. getting the evaluation of substantial equivalency from a provider of the service that is approved by the fbpe passing the principles & practice examination in order to verify an applicant's experience, the fbpe: follows guidelines set forth in rule 61615 20.002, f. a.c. relies on information obtained from personal references requires evidence of employment from employers or supervisors who are employed in the engineering profession. • all of the above.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
Which one of the following activities is not exempt from licensure pursuant to chapter 471, f. s.?...
Questions
question
English, 21.08.2020 01:01
question
Mathematics, 21.08.2020 01:01
Questions on the website: 13722363