Engineering, 04.01.2020 04:31 uniqueray33

Technician a says that load-carrying ball joints should always have some play in them. technician b says that follower ball joints should never have some play in them. who is correct?

a. technician a
b. technician b
c. both a and b
d. neither a nor b

Answers: 2

Show answers

Another question on Engineering

Engineering, 06.07.2019 02:30

On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)

Answers: 2

Answer

Engineering, 06.07.2019 02:30

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

Answer

Engineering, 06.07.2019 03:20

Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing

Answers: 3

Answer

Engineering, 06.07.2019 05:20

Adrawing operation is to be performed on a perfectly plastic material with strength coefficient- 100 mpa and strain hardening exponent-0. neglect redundant strain. die/work material friction coefficient=0 a)-what is the drawing stress? if this stress is a function of the area reduction, state so. b)-what is the strength of the material after drawing? if this strength is a function of the area 4. reduction, state so. c)-what is the maximum area reduction possible?

Answers: 3

Answer

You know the right answer?

Technician a says that load-carrying ball joints should always have some play in them. technician b...

Questions