Engineering, 27.12.2019 05:31 ericavasquez824

Apipe with closed ends has a wall thickness of 10 mm and an inner diameter of 0.60 m. it filled with a gas at 20 mpa pressure and subjected to a torque about its long axis of 1200 kn·m. a. determine the three principal normal stresses and the maximum shear stress. recall from basic mechanics that: = t / b. if the pipe is constructed of oil-quenched and tempered 4340 steel with a yield strength of 1620 mpa, what is the safety factor against yielding using the tresca maximum shear stress criterion? c. prior to loading, an inside crack is discovered through 25% of the thickness of the sample. with this crack, what is the safety factor against fracture if the plane strain fracture toughness is 87.4mpa√m?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

You know the right answer?

Apipe with closed ends has a wall thickness of 10 mm and an inner diameter of 0.60 m. it filled with...

Questions