subject
Engineering, 26.12.2019 22:31 jzoda7318

Consider the following bcnf schema and a portion of a simple corporate database (type
information is not relevant to this question and is omitted):
emp(eid, ename, addr, sal, age, yrs, deptid)
dept(did, dname, floor, budget)
suppose you know that the following queries are the six most common queries in the workload
for this corporation and that all six are roughly equivalent in frequency and importance:
ï‚· list the id, name and address of employees in a user-specified age range
ï‚· list the id, name and address of employees who work in the department with a userspecified department name
ï‚· list the id and address of employees with a user- specified employee name
ï‚· list the overall average salary for employees
ï‚· list the average salary for employees of each age; that is, for each age in the database,
list the age and the corresponding average salary.
ï‚· list all the department information, ordered by department floor numbers.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Consider the following bcnf schema and a portion of a simple corporate database (type
informat...
Questions
question
Social Studies, 08.10.2019 10:30
question
History, 08.10.2019 10:30
question
Mathematics, 08.10.2019 10:30
Questions on the website: 13722367