subject
Engineering, 24.12.2019 05:31 princessjsl22

The goal of this project is to develop simulation program that operates a dc motor using pulse width modulation (pwm) to achieve a desired angular velocity, and utilizing a pid controller to maintain the desired velocity regardless of an abrupt change in loading (torque).

your design must meet the following requirements:
οƒ˜ use the data-sheet for portescap 08g61-205c dc motor. it is posted at titanium.
οƒ˜ the applied voltage should not exceed 9 volts.
οƒ˜ the initial external load carried by the motor is 0.5 mn. m, in addition to its internal friction torque
οƒ˜ set up the system so that it achieves 1000 rpm.
οƒ˜ set up the system so that at the 20-second point its external load suddenly changes to 1.0 mn. m.
οƒ˜ apply a control strategy to maintain the speed at 1000 rpm throughout the time, even after the abrupt
change in the load (torque) has occurred.
οƒ˜ computer simulations using simulink/simscape are required to confirm the above requirement

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
You know the right answer?
The goal of this project is to develop simulation program that operates a dc motor using pulse width...
Questions
question
Mathematics, 04.06.2021 18:20
question
Mathematics, 04.06.2021 18:20
question
Mathematics, 04.06.2021 18:20
question
Chemistry, 04.06.2021 18:20
question
English, 04.06.2021 18:20
Questions on the website: 13722367