Engineering, 20.12.2019 00:31 sarbjit879

Amanufacturing process that unintentionally introduces cracks to the surface of a part was used to produce load-bearingcomponents. the design requires that the component be able to withstand a stress of 450 mpa. the component failedcatastrophically in service. you are a failure analysis engineer who must determine whether the component failed due to an overload in service orflaws from the manufacturing process. the manufacturer claims that the components were polished to remove the cracksand inspected to ensure that no surface cracks were larger than 0.5 mm. the manufacturer believes the component faileddue to operator error. it has been independently verified that the 5—cm diameter part was subjected to a tensile load of 1 mn (106 n). thematerial from which the component is made has a fracture toughness of 75 mpa \/m, and an ultimate tensile strength of600 mpa. assume external cracks for which f = 1.12(a) who is at fault for the component failure, the manufacturer or the operator? show your work for both cases.(b) in addition to the analysis that you presented in (a), what features might you look for on the fracture surfaces to supportyour conclusion?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

Amanufacturing process that unintentionally introduces cracks to the surface of a part was used to p...

Questions