subject
Engineering, 19.12.2019 01:31 kadeWayne

Technician a says that to check for

excessive resistance in the wiring between

the alternator and the battery, a voltage-

drop test should be performed. technician

b says that if the charging system isn't

charging properly, the rear bearing of the

generator should be checked for

magnetism. which technician is correct?

a. technician b only

b. both technician a and technician b

c. technician a only

d. neither technician a nor technician b

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
question
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
question
Engineering, 06.07.2019 03:20
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
You know the right answer?
Technician a says that to check for

excessive resistance in the wiring between
Questions
question
Mathematics, 28.03.2021 23:00
Questions on the website: 13722363