Engineering, 18.12.2019 07:31 genesisdiaz5123
2.73 a fan within an insulated duct delivers moist air at the duct exit at 358c, 50% relative humidity, and a volumetric flow rate of 0.4 m3 /s. at steady state, the power input to the fan is 1.7 kw. the pressure in the duct is nearly 1 atm throughout. using the psychrometric chart, determine the temperature, in 8c, and relative humidity at the duct inlet.
Answers: 2
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10
When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?
Answers: 2
2.73 a fan within an insulated duct delivers moist air at the duct exit at 358c, 50% relative humidi...
Computers and Technology, 20.02.2022 14:00
Social Studies, 20.02.2022 14:00
Mathematics, 20.02.2022 14:00
Mathematics, 20.02.2022 14:00
Chemistry, 20.02.2022 14:00
Mathematics, 20.02.2022 14:00
Social Studies, 20.02.2022 14:00