Engineering, 17.12.2019 22:31 mccarthyrookie6491

Penn state civil and environmental engineering department just built a super-duper coal-fired power plant in altoona, pa. it is 1,100 mw (i. e., large) with 40% efficiency. we used local coal that is 14,000 btu/ pound. the sulfur content is 2%. we added a scrubber that is 65% efficient. a) h b) if all of the sulfur is oxidized to so2 and the epa insists on a 80% efficiency scrubber how much so2 4.0 pant i aloona, pa. i is 1.100mental ow much sulfur will we release per hour (pounds/hour)? would be released (report value in pounds so2/ kwh generated)?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

Penn state civil and environmental engineering department just built a super-duper coal-fired power...

Questions